I’ve been running Multilink PPP with FreeBSD for several years now. Multilink PPP (sometimes called MLPPP) is a subset of the PPP protocol that allows you to bond multiple PPP tunnels and treat them as one much larger tunnel. Several DSL providers (particularly TekSavvy in Canada) support Multilink PPP on their DSL networks, allowing users to bond multiple DSL lines into one large pipe.
The technical details of Multilink PPP are pretty simple, though it can be configured in either a packet splitting or round robin fashion. When configured for packet splitting, a router that is about to transmit a packet down an MLPPP link will first split the packet in half, then add a 6KB MLPPP header (really just a sequence number) to each half of the packet, and send the half-packets down each link. On the other end of the MLPPP link, the receiving router will take the two halves (identified by the matching MLPPP headers) and reconstitute the original packet. In round robin mode the MLPPP header is added to the whole packet (meaning the MTU of the link is 6KB smaller or else packet fragmentation will occur) and sent out the links in a round robin fashion.
In FreeBSD it’s easy to setup just about any Multilink PPP configuration you want. I’ve run it with three DSL lines (total usable throughput: 15 megabits). Presently I’m running over one DSL line but with two PPPoE tunnels first multiplexed at the DSL frame level and then bonded at the PPP level. The purpose of this is to circumvent Bell Canada’s throttling, which they apply to both their own residential customers and to their third-party wholesale partners, like TekSavvy.